Robert Sawyer
70% Staudacher

70% Staudacher Taking Up the Street Robert Sawyer with 70% Staudacher 70% Staudacher in Garage with 40% Edge
Engine Head On 1/4 shot of Engine, showing mount Side shot, showing engine mount Inside the Fuselage Inside the fuse, facing forward, showing fuel tank

General Info:

Wing span
 : 208"
Fuselage length
 : 192"
Weight ( dry )
 : 350 lbs

Motor used:

Name
 : HKS 700cc Four Cycle Opposed
Muffler
 :
Props
 : Power Fin 3-Bladed 64" Diameter, Ground Pitch Adjustable
Fuel / Oil
 :
Spinner
 :

Radio / Servos:

Radio
 : JR-10x
Receiver
 :

Servos:

Rudder
 : Seiko UAV Scale
Elevators
 : Seiko UAV Scale
Ailerons
 : Seiko UAV Scale
Throttle
 : Seiko UAV Scale

Linkages:

Clevis's
 :
Pushrod's
 :
Servo Arm's
 :

Batteries:

Receiver
 : 34 AH Aircraft Battery, on a 12V system
Ignition
 :
Regulators
 : Power routed through a custom Voltage Regulation and Filtration System by Power Flight

Covering and paint:

Covering
 : Unpainted as of yet
Paint
 :
Graphics
 :

Channels:

Rudder      : 
Elevator    :
Ailerons     :
Throttle     : 

Built by / when:

Built by          : Robert Sawyer
Covered by   :
Paint by         :

Where flown ?

    : Unflown, as of yet

Comments on plane:

CONSTRUCTED FROM: Aircraft grade mohogany plywood, spruce, fiberglass & carbon pre pregnated, and Nomex honey comb. This aircraft has a 12 volt system, onboard starter, and an onboard charge system. With a 34 AH aircraft battery all power is routed through a custom designed voltage regulation and filtration system by POWER FLIGHT. The output from the charging system is enough to fly the airplane, shoud I lose battery power.

 

Current status :

Plane is currently (4-1-02) undergoing preparation for paint, so it is unflown.